Zyxel-communications ZYWALL10 Bedienungsanleitung PDF herunterladen (Seite 115)

ZyWALL 10 Internet Security Gateway

7-16 Filters

the raw packets that appear on the wire. They are applied at the point when the ZyWALL is receiving and

sending the packets; i.e. the interface. The interface can be an Ethernet port or any other hardware port. The

following diagram illustrates this.

Figure 7-15 Protocol and Device Filter Sets

7.5 Firewall

Firewall configuration is discussed in Part 4 of this manual. Further comparisons are also made there

between filtering, NAT and the firewall.

7.6 Applying a Filter and Factory Defaults

This section shows you where to apply the filter(s) after you design it (them). Sets of factory default filter

rules have been configured in menu 21 to prevent NetBIOS traffic from triggering calls, and block

incoming telnet, FTP and HTTP connections.

If you do not activate the firewall, it is advisable to apply these default filters as

shown next.

7.6.1 LAN traffic

LAN traffic filter sets may be useful to block certain packets, reduce traffic and prevent security breaches.

Go to menu 3.1 (shown next) and enter the number(s) of the filter set(s) that you want to apply as

appropriate. You can choose up to four filter sets (from twelve) by entering their numbers separated by

commas, e.g., 3, 4, 6, 11. Input filter sets filter incoming traffic to the ZyWALL and output filter sets filter

outgoing traffic from the ZyWALL. The factory default set, NetBIOS_LAN, can be inserted in the protocol

filters field under Input Filter Sets in menu 3.1 to block NetBIOS traffic to the ZyWALL from the LAN.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 266 267

Keine Kommentare

Zyxel-communications ZYWALL10 Bedienungsanleitung Seite 115