Zyxel-communications P-660HW-D Series Bedienungsanleitung PDF herunterladen (Seite 63)

P-660HW-D Series User’s Guide

Chapter 3 Wizard Setup for Internet Access 62

The following table describes the labels in this screen.

Note: The wireless stations and ZyXEL device must use the same SSID, channel ID

and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is

enabled) for wireless communication.

4 This screen varies depending on the security mode you selected in the previous screen.

Fill in the field (if available) and click Next.

3.3.1 Manually assign a WPA-PSK key

Choose Manually assign a WPA-PSK key in the Wireless LAN setup screen to set up a Pre-

Shared Key.

Table 14 Wireless LAN Setup Wizard 2

LABEL DESCRIPTION

Network

Name(SSID)

Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless

LAN.

If you change this field on the ZyXEL device, make sure all wireless stations use the

same SSID in order to access the network.

Channel

Selection

The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a

channel. Select a channel ID that is not already in use by a neighboring device.

Security Select Automatically assign a WPA key (Recommended) to have the ZyXEL device

create a pre-shared key (WPA-PSK) automatically only if your wireless clients support

WPA and OTIST. This option is availeble only when you enable OTIST in the previous

wizard screen.

Select Manually assign a WPA-PSK key to configure a pre-shared key (WPA-PSK).

Choose this option only if your wireless clients support WPA. See Section 3.3.1 on

page 62 for more information.

Select Manually assign a WEP key to configure a WEP Key. See Section 3.3.2 on

page 63 for more information.

Select Disable wireless security to have no wireless LAN security configured and

your network is accessible to any wireless networking device that is within range.

Note: If you enable OTIST in the previous wizard screen but select

Disable wireless security here, the ZyXEL device still creates

a pre-shared key (WPA-PSK) automatically.

If you enable OTIST and select Manually assign a WEP key,

the ZyXEL device will replace the WEP key with a WPA-PSK.

Back Click Back to display the previous screen.

Next Click Next to proceed to the next screen.

Exit Click Exit to close the wizard screen without saving.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 338 339

Keine Kommentare

Zyxel-communications P-660HW-D Series Bedienungsanleitung Seite 63