Zyxel-communications Prestige 2602R Series Bedienungsanleitung PDF herunterladen (Seite 261)

Prestige 2602R Series User’s Guide

Chapter 26 Static Route Setup 261

The following table describes the fields for Menu 12.1.1 – Edit IP Static Route Setup.

Table 87 Menu12.1.1 Edit IP Static Route

FIELD DESCRIPTION

Route # This is the index number of the static route that you chose in menu 12.1.

Route Name Type a descriptive name for this route. This is for identification purpose only.

Active This field allows you to activate/deactivate this static route.

Destination IP

Address

This parameter specifies the IP network address of the final destination.

Routing is always based on network number. If you need to specify a route to a

single host, use a subnet mask of 255.255.255.255 in the subnet mask field to

force the network number to be identical to the host ID.

IP Subnet Mask Type the subnet mask for this destination. See Section 4.5.1 on page 73 in this

manual.

Gateway IP Address Type the IP address of the gateway. The gateway is an immediate neighbor of

your Prestige that will forward the packet to the destination. On the LAN, the

gateway must be a router on the same segment as your Prestige; over WAN,

the gateway must be the IP address of one of the remote nodes.

Metric Metric represents the cost of transmission for routing purposes. IP routing uses

hop count as the measurement of cost, with a minimum of 1 for directly

connected networks. Type a number that approximates the cost for this link.

The number need not be precise, but it must be between 1 and 15. In practice,

2 or 3 is usually a good number.

Private This parameter determines if the Prestige will include the route to this remote

node in its RIP broadcasts. If set to Yes, this route is kept private and is not

included in RIP broadcasts. If No, the route to this remote node will be

propagated to other hosts through RIP broadcasts.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm

or ESC to Cancel:

” to save your configuration, or press [ESC] at any time to cancel.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 449 450

Keine Kommentare

Zyxel-communications Prestige 2602R Series Bedienungsanleitung Seite 261