Zyxel-communications Prestige 645R-A Series Bedienungsanleitung Seite 243
- Seite / 251
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Prestige 645R-A Series User’s Guide
Splitters and Microfilters F-1
Appendix F
Splitters and Microfilters
This appendix tells you how to install a POTS splitter or a telephone microfilter.
Connecting a POTS Splitter
When you use the Full Rate (G.dmt) ADSL standard, you can use a POTS (Plain Old Telephone Service)
splitter to separate the telephone and ADSL signals. This allows simultaneous Internet access and telephone
service on the same line. A splitter also eliminates the destructive interference conditions caused by
telephone sets.
Install the POTS splitter at the point where the telephone line enters your residence, as shown in the
following figure.
Diagram F-1 Connecting a POTS Splitter
Step 1. Connect the side labeled “Phone” to your telephone.
Step 2. Connect the side labeled “Modem” to your Prestige.
Step 3. Connect the side labeled “Line” to the telephone wall jack.
Telephone Microfilters
Telephone voice transmissions take place in the lower frequency range, 0 - 4KHz, while ADSL transmissions
take place in the higher bandwidth range, above 4KHz. A microfilter acts as a low-pass filter, for your
telephone, to ensure that ADSL transmissions do not interfere with your telephone voice transmissions. The
use of a telephone microfilter is optional.
Step 1. Connect a phone cable from the wall jack to the single jack end of the Y- Connector.
- Prestige 645R-A series 1
- Copyright 2
- (FCC) Interference Statement 3
- ZyXEL Limited Warranty 4
- Customer Support 5
- Table of Contents 6
- List of Figures 12
- List of Tables 16
- List of Charts 18
- Preface 19
- Introduction to DSL 21
- Part I: 23
- Chapter 1 25
- 1.3.1 Internet Access 27
- Chapter 2 29
- Hardware Installation 29
- 2.2.1 DSL Port 30
- 2-4 Hardware Installation 32
- Chapter 3 33
- Wizard Setup 34
- Navigation panel 34
- 3.4 Configuring Password 35
- 3.5 Resetting the Prestige 36
- Chapter 4 37
- 4.3 Multiplexing 38
- 4.4 VPI and VCI 38
- DESCRIPTION 39
- 4.7 IP Address Assignment 41
- 4.9 NAT 42
- 4.10.1 PPPoE 43
- 4.10.2 RFC 1483 44
- 4.10.3 ENET ENCAP 45
- 4.10.4 PPPoA 46
- 4.11 Basic Setup Complete 48
- Part II: 49
- Chapter 5 51
- LAN Setup 51
- 5.4 LAN TCP/IP 52
- 5.4.3 RIP Setup 53
- 5.4.4 Multicast 53
- 5.5 Configuring LAN 54
- LAN Setup 5-5 55
- Table 5-1 LAN 55
- Chapter 6 57
- 6.1.3 How NAT Works 58
- 6.1.4 NAT Application 59
- 6.1.5 NAT Mapping Types 59
- 6.3 SUA Server 61
- 6.4 Selecting the NAT Mode 63
- 6.5 Configuring SUA Server 64
- LABEL DESCRIPTION 65
- NAT 6-13 69
- Chapter 7 71
- Dynamic DNS Setup 71
- Part III: 73
- Chapter 8 75
- Maintenance 8-3 77
- Table 8-1 System Status 77
- 8.2.1 System Statistics 78
- Maintenance 8-5 79
- 8.3 DHCP Table Screen 80
- 8.4 Diagnostic Screens 81
- 8.5 Firmware Screen 84
- Part IV: 87
- Chapter 9 89
- Introducing the SMT 89
- ? > or ChangeMe 91
- Chapter 10 95
- General Setup 95
- 10-2 General Setup 96
- Chapter 11 99
- Ethernet Setup 99
- Chapter 12 103
- Internet Access 103
- 12.4 IP Alias Setup 104
- Edit IP Alias= Yes 105
- 12.5 Route IP Setup 106
- Chapter 13 109
- Remote Node Configuration 109
- 13.3 Metric 113
- 13.5 Remote Node Filter 117
- Separate VPI and 121
- VCI numbers must 121
- Only one set of VPI 122
- Chapter 14 123
- Static Route Setup 123
- Static Route Setup 14-3 125
- 14-4 Static Route Setup 126
- Chapter 15 127
- Bridging Setup 127
- Bridge= Yes 128
- Edit IP/Bridge= Yes 128
- 15-4 Bridging Setup 130
- Chapter 16 131
- NAT= SUA Only 132
- 16.3 NAT Setup 133
- 16.3.1 Address Mapping Sets 134
- FIELD DESCRIPTION EXAMPLE 136
- 16.5 General NAT Examples 141
- NAT= Full Feature 145
- Type= One-to-One 146
- Start= 192.168.1.10 146
- Start= 10.132.50.1 146
- Part V: 149
- Chapter 17 151
- Filter Configuration 151
- Outgoing 152
- Filter Rule 153
- Filter Set 153
- FIELD DESCRIPTION 156
- Len Length 157
- 17.3.1 TCP/IP Filter Rule 158
- Filter Configuration 17-9 159
- 17.3.2 Generic Filter Rule 162
- 17.4 Filter Types and NAT 164
- 17.5 Example Filter 164
- 17.6.1 Ethernet Traffic 168
- 17.6.2 Remote Node Filters 168
- Chapter 18 171
- SNMP Configuration 171
- 18.2 Supported MIBs 172
- 18.3 SNMP Configuration 172
- 18.4 SNMP Traps 174
- Chapter 19 175
- 19.3 System Information 177
- 19.4 Log and Trace 179
- 19.4.2 Syslog and Accounting 180
- 19.5 Diagnostic 182
- Chapter 20 185
- Maintenance 185
- 20.2 Backup Configuration 186
- 20.2.1 Backup Configuration 187
- 20.2.4 GUI-based FTP Clients 188
- 20.2.7 TFTP Command Example 189
- 20.3 Restore Configuration 190
- 20.4.1 Firmware File Upload 192
- 20.4.5 TFTP File Upload 194
- Chapter 21 197
- IP Policy Routing 197
- IP Policy Routing 21-3 199
- 21.5 Applying an IP Policy 201
- IP Policies= 1,2 205
- Chapter 22 207
- Call Scheduling 207
- Part VI: 211
- Appendix A 213
- Troubleshooting 213
- A.2 Telnet 214
- A.3 Web Configurator 215
- A.5 LAN Interface 216
- A.6 WAN Interface 216
- A.7 Internet Access 217
- A.8 Remote Node Connection 218
- Appendix B 219
- IP Subnetting 219
- B-8 IP Subnetting 226
- Appendix C 227
- Appendix D 229
- Installing Components 230
- Configuring 230
- Verifying Settings 232
- Windows 2000/NT/XP 233
- Macintosh OS 8/9 237
- Appendix E 241
- Virtual Circuit Topology 241
- Appendix F 243
- Splitters and Microfilters 243
- Appendix G 245
- Appendix H 247
Verwandte Produkte und Handbücher für Hardware Zyxel-communications Prestige 645R-A Series
(430 Seiten)
(33 Seiten)
(10 Seiten)Philips SC5274/13 manuály
Uživatelské manuály a uživatelské příručky pro DVD přehrávače Philips SC5274/13.
Poskytujeme manuály pdf Philips SC5274/13 ke stažení zdarma podle typů dokumentů:
Kommentare zu diesen Handbüchern