ZyXEL Communications P-660 series Betriebsanweisung PDF herunterladen (Seite 151)

Chapter 11 Quality Of Service

P-660R-F1 Series User’s Guide

151

11.3 The Class Setup Screen

Use this screen to add, edit or delete classifiers. A classifier groups traffic into data flows according

to specific criteria such as the source address, destination address, source port number, destination

port number or incoming interface. For example, you can configure a classifier to select traffic from

the same protocol port (such as Telnet) to form a flow.

Click Advanced > QoS > Class Setup to open the following screen.

Figure 93 Advanced > QoS > Class Setup

The following table describes the labels in this screen.

Table 56 Advanced > QoS > Class Setup

LABEL DESCRIPTION

Create a new Class Click this to create a new classifier.

No This is the number of each classifier. The ordering of the classifiers is important

as the classifiers are applied in turn.

Active Select the check box to enable this classifier.

Name This is the name of the classifier.

Interface This shows the interface from which traffic of this classifier should come.

Priority This is the priority assigned to traffic of this classifier.

Filter Content This shows criteria specified in this classifier.

Modify Click the Edit icon to go to the screen where you can edit the classifier.

Click the Remove icon to delete an existing classifier.

Apply Click this to save your changes.

Cancel Click this to restore your previously saved settings.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 267 268

Keine Kommentare

ZyXEL Communications P-660 series Betriebsanweisung Seite 151