ZyXEL Communications STB-1003 Bedienerhandbuch PDF herunterladen (Seite 5)

07.27.11

ENTONE REMOTE

Programming Instructions

A brand new ENTONE remote control must first be registered with

the set top box (STB) before it can be manually programmed to a

specific TV. Program Remote # 1 to channel 10 or the HD Stream,

Remote # 2 to channel 23 and Remote #3 to channel 39.

1. Press and hold for 10 seconds the “STB” button on remote while pressing “OK” button on the front of the ENTONE

set top box. When releasing the “OK” button, the ENTONE set top box front panel will display “RC REG” to indicate

registration mode. The “STB” button will stay lit once the button is released.

2. Press “STB” once. The “STB” & “AUX” buttons will light to indicate that the remote control is in registration mode.

• Register the #1 Remote by pressing 1 on the remote.

• The “STB” button will blink twice to indicate the registration process was successful.

• Register each remote in the same manner.

• Press “2” on the #2 remote to register and press “3” on the #3 remote to register.

1. Turn on TV and tune to correct channel.

MANUALLY PROGRAM TO TV or Device – Be in front of specific TV:

2. Press “TV”

3. Press and hold “SETUP” until TV button blinks twice.

4. Enter 4 digit code from Appendix A.

1. Turn on TV and tune to correct channel.

AUTO PROGRAM – Use this method if TV or device code is not available or did not work:

2. Press “TV”

3. Press and hold “SETUP” until TV button blinks twice

4. Press “POWER” then “CHANNEL UP” one time.

The remote will go through a code every 5 sec. To speed up the process, arrow up until the TV shuts off.

5. Press “OK”.

1. TV should be ON.

SET POWER BUTTON- In front of specific TV using the corresponding remote control:

2. Press “STB”

3. Press and hold “SETUP” until STB button blinks twice

4. Press “POWER” then “1”

1. Press “MENU”

TO SET AUTO-LOGIN – This will enable Auto-Login, so a

password is not required when TV is turned on:

2. Press “OK” on Settings

3. Press “OK” on Account

4. Press “OK” on Auto Login

5. Press “OK” twice (1 time to set & 1 time to confirm)

6. Press “EXIT” 3 times

1 2 3 4 5 6 7 8 9 10 ... 38 39

Keine Kommentare

ZyXEL Communications STB-1003 Bedienerhandbuch Seite 5