Zyxel-communications NBG334SH Bedienungsanleitung PDF herunterladen (Seite 237)

Appendix E Setting up Your Computer’s IP Address

ZyXEL NBG-334SH User’s Guide

237

Figure 146 Red Hat 9.0: KDE: Network Configuration: Activate

7 After the network card restart process is complete, make sure the Status is Active in the

Network Configuration screen.

Using Configuration Files

Follow the steps below to edit the network configuration files and set your computer IP

address.

1 Assuming that you have only one network card on the computer, locate the

ifconfig-

eth0

configuration file (where eth0 is the name of the Ethernet card). Open the

configuration file with any plain text editor.

• If you have a dynamic IP address, enter

dhcp in the BOOTPROTO= field. The

following figure shows an example.

Figure 147 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0

• If you have a static IP address, enter static in the BOOTPROTO= field. Type

IPADDR= followed by the IP address (in dotted decimal notation) and type NETMASK=

followed by the subnet mask. The following example shows an example where the

static IP address is 192.168.1.10 and the subnet mask is 255.255.255.0.

Figure 148 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0

DEVICE=eth0

ONBOOT=yes

BOOTPROTO=dhcp

USERCTL=no

PEERDNS=yes

TYPE=Ethernet

DEVICE=eth0

ONBOOT=yes

BOOTPROTO=static

IPADDR=192.168.1.10

NETMASK=255.255.255.0

USERCTL=no

PEERDNS=yes

TYPE=Ethernet

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 289 290

Keine Kommentare

Zyxel-communications NBG334SH Bedienungsanleitung Seite 237