
Chapter 6 Wireless Tutorial
NBG334W User’s Guide
97
Follow the steps below to configure the wireless settings on your NBG334W.
The instructions require that your hardware is connected (see the Quick Start Guide) and you
are logged into the web configurator through your LAN connection (see Section 2.2 on page
35).
1 Open the Wireless LAN > General screen in the AP’s web configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the
Pre-Shared Key field. Click Apply.
Figure 49 Network > Wireless LAN > General
5 Open the Status screen. Verify your wireless and wireless security settings under Device
Information and check if the WLAN connection is up under Interface Status.
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
Kommentare zu diesen Handbüchern