Zyxel-communications P-2608HWL-Dx Series Bedienungsanleitung PDF herunterladen (Seite 101)

P-2608HWL-Dx Series User’s Guide

Chapter 7 WAN Setup 101

Multiplexing Select the method of multiplexing used by your ISP from the drop-down list.

Choices are VC or LLC.

Virtual Circuit ID VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual

circuit. Refer to the appendix for more information.

VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.

VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management

of ATM traffic). Enter the VCI assigned to you.

IP Address This option is available if you select Routing in the Mode field.

A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is

not fixed; the ISP assigns you a different one each time you connect to the Internet.

Select Obtain an IP Address Automatically if you have a dynamic IP address;

otherwise select Static IP Address and type your ISP assigned IP address in the

IP Address field below.

Subnet Mask

(ENET ENCAP

encapsulation

only)

Enter a subnet mask in dotted decimal notation.

Refer to the appendix to calculate a subnet mask If you are implementing

subnetting.

Gateway IP

address

(ENET ENCAP

encapsulation

only)

You must specify a gateway IP address (supplied by your ISP) when you select

ENET ENCAP in the Encapsulation field

Connection

(PPPoA and

PPPoE

encapsulation

only)

Nailed-Up

Connection

Select Nailed-Up Connection when you want your connection up all the time. The

ZyXEL Device will try to bring up the connection automatically if it is disconnected.

Connect on

Demand

Select Connect on Demand when you don't want the connection up all the time

and specify an idle time-out in the Max Idle Timeout field.

Max Idle Timeout Specify an idle time-out in the Max Idle Timeout field when you select Connect on

Demand. The default setting is 0, which means the Internet session will not timeout.

NAT Use this section to activate NAT for this connection.

None Select this if you don’t want this WAN connection to use NAT.

SUA Only Select this to use Single User Account NAT settings, then click Edit Detail to

configure your settings. See Section 10.1 on page 139 for more details.

Back Click Back to return to the previous screen.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

Advanced Setup Click this button to display the Advanced Setup screen and edit more details of

your additional WAN connections. See Section 7.5.1 on page 97 for more

information on this screen.

Table 27 WAN More Connections > Modify (continued)

LABEL DESCRIPTION

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 450 451

Kommentare zu diesen Handbüchern

Keine Kommentare

Zyxel-communications P-2608HWL-Dx Series Bedienungsanleitung Seite 101

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Zyxel-communications P-2608HWL-Dx Series