Zyxel-communications WPA-1000 Bedienungsanleitung PDF herunterladen (Seite 54)

Chapter 5 Troubleshooting

WPA-1000 User’s Guide

V My WPA-1000 cannot connect to a projector. The standby screen does not

appear.

1 Check the projector is turned on and working properly.

2 Check your gray VGA cable is securely attached to the WPA-1000 and to the projector.

3 Turn the projector off and then on.

5.2 WPA-1000 Access and Login

V I forgot the IP address for the WPA-1000.

1 The default IP address is 192.168.1.10.

2 If you changed the IP address and have forgotten it, you might get the IP address of the

WPA-1000 by looking up the IP address of the default gateway. To do this in most

Windows computers, click Start > Run, enter cmd, and then enter ipconfig. The IP

address of the Default Gateway might be the IP address of the WPA-1000 (it depends

on the network), so enter this IP address in your Internet browser.

3 If this does not work, you have to reset the device to its factory defaults. See Section 5.5

on page 58.

V I forgot the password.

1 The default password is 1234.

2 If this does not work, you have to reset the device to its factory defaults. See Section 5.5

on page 58.

V I cannot see or access the Login screen in the web configurator.

1 Make sure you are using the correct IP address.

• The default IP address is 192.168.1.10.

• If you changed the IP address (Section 5.1 on page 53), use the new IP address.

• If you changed the IP address and have forgotten it, see the troubleshooting

suggestions for I forgot the IP address for the WPA-1000.

2 Check the hardware connections, and make sure the LEDs are behaving as expected. See

the Quick Start Guide and Section 2.1 on page 25.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 159 160

Keine Kommentare

Zyxel-communications WPA-1000 Bedienungsanleitung Seite 54