
Chapter 5 AP Mode
NWD2105 User’s Guide
77
See Also...
The terms and concepts introduced in Chapter 4 on page 49 apply to this chapter
as well.
5.1.3 Before You Begin
Make sure the ZyXEL Utility is already installed. See the Quick Start Guide for
more.
To bridge your wired and wireless network using the NWD2105, the following
requirements must be met:
• The NWD2105 must be installed on a computer connected to the wired network.
• Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen) or configure network sharing.
• Set the wireless station’s IP address to be dynamic if you want the wireless
stations to access the wired network or the Internet through the NWD2105.
Refer to Appendix A on page 101 for how to configure your computer’s IP
address.
5.2 AP Mode Screen Summary
This section describes the ZyXEL Utility screens while in AP Mode.
Figure 55 ZyXEL Utility Menu Summary
The following table describes the menus.
Table 20 ZyXEL Utility Menu Summary
TAB DESCRIPTION
Link Info Use this screen to see your current connection status, configuration and
data rate statistics.
Configuration Use this screen to configure wireless LAN settings.
MAC Filter Use this screen to configure which computer(s) you want access to the
wireless LAN through the NWD2105.
Kommentare zu diesen Handbüchern