ZyXEL Communications Prestige 642M series Betriebsanweisung Seite 75
- Seite / 155
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Prestige 642 ADSL Internet Access Router
4-4 Remote Node Configuration
Field Description Options
z
CHAP/PAP - Your Prestige will accept either CHAP or
PAP when requested by this remote node.
CHAP/PAP
z
CHAP - accept CHAP only.
CHAP
z
PAP - accept PAP only.
PAP
Route This field determines the protocols that your Prestige will
route.
Bridge Bridging is used for protocols that the Prestige does not
support, e.g., SNA, or not turned on in the previous Route
field. When bridging is enabled, your Prestige will forward
any packet that it does not route to this remote node;
otherwise, the packets are discarded. Press space bar to
toggle the options.
Yes
or
No
Edit PPP Options To edit the PPP options for this remote node, move the
cursor to this field, use the space bar to select Yes and
press [ENTER]. This will bring you to Menu 11.2 - Remote
Node PPP Options. For more information on configuring
PPP options, see the section Editing PPP Options. Press
space bar to toggle
Yes
then press [ENTER].
Rem IP Addr Enter the IP address of the remote gateway.
Edit IP/IPX/Bridge Press the space bar to select Yes and press ENTER to go
to Menu 11.3 - Remote Node Network Layer Options menu.
Yes
or
No
Session Option:
Edit Filter Sets
Use the space bar to toggle this field to Yes and press
[ENTER] to open Menu 11.5 to edit the filter sets. See the
Remote Node Filter section for more details.
Default=
No
PPPoE Idle
Timeout(sec)=
This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session.
100
(default)
PPPoE Service Name
This is valid only when you have chosen
PPPoE
encapsulation. If you are using PPPoE encapsulation, then
type the name of your PPPoE service here.
poellc
Once you have completed filling in Menu 11.1 – Remote Node Profile, press [ENTER] at the message
[Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to cancel.
4.1.3 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor’s implementation includes specific authentication protocol in the user profile. It
- Prestige 642 1
- Part I: 2
- Part II: 3
- Part III: 4
- Chapter 8 6
- Filter Configuration 6
- Filter Rule 8
- Filter Set 8
- 8.2 Configuring a Filter Set 9
- Filter Configuration 8-5 10
- 8.2.3 TCP/IP Filter Rule 13
- Filter Configuration 8-9 14
- 8-10 Filter Configuration 15
- Filter Configuration 8-11 16
- 8-12 Filter Configuration 17
- 8.2.4 Generic Filter Rule 18
- 8.2.5 Novell IPX Filter Rule 19
- 8-16 Filter Configuration 21
- 8.3 Example Filter 22
- 8.4 Filter Types and SUA 24
- 8.5.1 LAN traffic 25
- 8.5.2 Remote Node Filters 26
- Chapter 9 28
- SNMP Configuration 28
- 9-2 SNMP Configuration 29
- Chapter 10 30
- System Maintenance 30
- 10.1 System Status 31
- System Maintenance 10-3 32
- is as follows 32
- 10.2 Log and Trace 34
- 10.2.2 Syslog And Accounting 35
- 10.3 Diagnostic 38
- 10.4.1 Firmware Development 39
- 10.5 Backup Configuration 40
- 10.6 Restore Configuration 41
- 10.7 Upload Firmware 42
- 10.8 TFTP Transfer 44
- 10.9 FTP File Transfer 45
- 10.11 Boot module commands 48
- 10-20 System Maintenance 49
- Chapter 11 50
- IP Policy Routing 50
- IP Policy Routing 11-3 52
- 11.2 Applying an IP Policy 54
- Chapter 12 56
- Troubleshooting 56
- 12-2 Troubleshooting 57
- Glossary 58
- B Glossary 59
- D Glossary 61
- Appendix A 64
- Appendix B 66
- Chapter 4 72
- Remote Node Configuration 72
- Remote Node Configuration 4-3 74
- 4-4 Remote Node Configuration 75
- 4.1.4 Editing PPP Options 76
- 4.1.5 Remote Node Filter 77
- Chapter 5 78
- 5.1.2 Static Route Setup 82
- Menu 12 - Static Route Setup 83
- Chapter 6 86
- IPX Configuration 86
- 6.3 IPX Ethernet Setup 89
- 6.4.1 IPX Remote Node Setup 91
- 6.4.2 IPX Static Route Setup 92
- IPX Configuration 6-9 94
- Chapter 7 96
- Bridging Setup 96
- Handle IPX= None 97
- Press Space Bar to Toggle 97
- Bridging Setup 7-5 100
- Chapter 1 104
- 1.3.1 Internet Access 106
- 1.3.2 LAN to LAN Application 107
- Chapter 2 108
- 2.5 Telephone Microfilters 110
- 2.6 Power Up Your Prestige 111
- Enter Password : XXXX 112
- 2.9 General Setup 115
- 2.10 Ethernet Setup 116
- Chapter 3 118
- Internet Access 118
- 3.3 TCP/IP Parameters 119
- 3.3.4 DHCP Configuration 120
- 3.4 IP Multicast 121
- 3.5 IP Policies 121
- 3.6 IP Alias 121
- 3.7 Route IP Setup 122
- Internet Access 3-7 124
- 3.9 VPI & VCI 125
- 3.10 Multiplexing 125
- 3.11 Encapsulation 125
- 3.12 IP Address Assignment 126
- Internet Access 3-11 128
- 3.14 Single User Account 129
- Customer Support 137
- Table of Contents 138
- List of Figures 143
- List Of Tables 147
- What is DSL? 151
- Standards 154
Verwandte Produkte und Handbücher für Vernetzung ZyXEL Communications Prestige 642M series
(46 Seiten)
(168 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern