ZyXEL Communications ZYWALL 5 - V4.04 Betriebsanweisung PDF herunterladen (Seite 147)

ZyXEL Confidential

404XD3C0.docx

147/181

31. [BUG FIX]

Symptom: Save a legal VPN gateway policy but the ZyWALL shows an error

message.

Condition:

(1) GO to eWC>VPN>GATEWAY POLICY – EDIT

(2) Save a GATEWAY POLICY whose name = GW, My Address =

www.abc.com.tw, Remote Gateway Address = www.cde.com.tw and Pre-Shared

Key = 12345678

(3) GO to eWC>VPN>NETWORK POLICY - EDIT

(4) Save a NETWORK POLICY whose name = NW, Active = Yes, Starting IP

Address = 192.168.1.33, Starting IP Address = 192.168.2.33 and Pre-Shared Key

= 12345678

(5) Go back to eWC>VPN>Rules and edit rule "GW" and set its My Address as

0.0.0.0, then save

(6) The ZyWALL shows an error message "This IKE rule has static policy rules.", but

it should not.

32. [BUG FIX]

Symptom: There are no logs in eWC>Logs>Log Settings when SMTP authentication

fail .

Condition:

(1) Go to eWC>Logs>Log Settings. Configure a wrong Mail Server/Send Log

to/Send Alerts to/ User Name of SMTP Authentication/Password of SMTP

Authentication and save.

(2) Go to eWC>Logs>View Log. There are no logs about SMTP Auth failures/SMTP

failures.

(3) If the configuration is correct. There is also no log to tell users that the result is

successful.

33. [ENHANCEMENT] Add port information in centralized log message when a netbios

packet was blocked.

34. [ENHANCEMENT] After the device rebooting, the system will synchronize Time

server until any WAN is up or all WAN links are failed exceed 5 minutes. If NTP

server is on LAN/DMZ subnet, DUT still won’t sync when WAN interface is down.

35. [BUG FIX]

Symptom: VPN tunnel can be established but traffic cannot go through tunnel.

Condition: PC1 -- ZyWALL -- Any Router/Internet -- ZyWALL -- PC2

(1) Configure corresponding VPN setting in both ZyWALLs.

(2) Dial VPN tunnel

(3) After tunnel established, PC1 cannot ping PC2 vice versa.

36. [BUG FIX]

Symptom: The router cannot flush correctly in eWC->LOGS->Reports.

Condition:

(1) In Bridge Mode.

(2) In eWC->LOGS->Reports, enable “Collect Statistics”, interface = LAN, Report

type= "Host IP Address".

(3) When pressing "Flush" button, there is still one record existing "192.168.70.123

Outgoing 3913 bytes". "192.168.70.123" is router's IP address.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 180 181

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications ZYWALL 5 - V4.04 Betriebsanweisung Seite 147

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ZyXEL Communications ZYWALL 5 - V4.04