ZyXEL Communications MAX218MW Betriebsanweisung PDF herunterladen (Seite 48)

Chapter 6 Wireless LAN

WRE2205 User’s Guide

Figure 34 Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

6.10 AP Select Screen

Use this screen to choose an access point that you want the WRE2205 to connect to. You should

know the security settings of the target AP.

To open this screen, click Network > Wireless LAN > AP Select tab.

Figure 35 Network > Wireless LAN > AP Select

Table 18 Network > Wireless LAN > WPS Station

LABEL DESCRIPTION

Config Mode Use this to select Registrar or Enrollee mode. Select Registrar mode to make wireless

clients follow the wireless settings of the WRE2205. Select Enrollee mode to make the

WRE2205 follow the wireless settings of an access point.

Push Button Use this button when you use the PBC (Push Button Configuration) method to configure

wireless stations’s wireless settings. See Section 5.2.1 on page 29.

Click this to start WPS-aware wireless station scanning and the wireless security

information synchronization.

Input station’s

PIN number

Use this button when you use the PIN Configuration method to configure wireless station’s

wireless settings. See Section 5.2.2 on page 31.

Type the same PIN number generated in the wireless station’s utility. Then click Start to

associate to each other and perform the wireless security information synchronization.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 73 74

Keine Kommentare

ZyXEL Communications MAX218MW Betriebsanweisung Seite 48