ZyXEL Communications U-1496 series Bedienungsanleitung Seite 56

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 108
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 55
&N43 CELL 12000
&N44CELL 9600
&N45 CELL 7200
&N46 CELL 4800T
&N47 CELL 4800C
&N48 CELL 3866C
&N49 CELL 2400C
Note: All speeds over 9600 bps are trellis coded except V.29; V.32bis 7200 is also trellis coded.
Not all modes available in all models. Check the compatibility table. All ZyXEL modes except
ZyXEL 16800 are available only with Plus models.
+ &P0 Pulse dial make/break ratio= 39%/61% (Default).
&P1 Pulse dial make/break ratio= 33%/67%.
&R0 CTS tracks RTS, response delay is set in S26.
+ &R1 Modem assumes RTS always ON, ignores the changes (Default). (&Rn controls
the synchronous mode operation only, in asynchronous mode RCTS/RTS are used for flow
control.)
+ &S0 Modem forces DSR always ON (Default).
&S1 DSR according to CCITT. If S44b4=1, DSR follows DTR. If S41b5=1, DSR
always on but follows DCD off for 0.5 second.
&T0 Terminate test in progress.
&T1 Initiate Analog LoopBack (ALB) test.
&T2 Reserved.
&T3 Initiate Local Digital Loopback (LDL) test.
&T4 Grant Remote Digital Loopback request from remote modem.
&T5 Deny Remote Digital Loopback request from remote modem (Default).
&T6 Initiate Remote Digital Loopback (RDL) test.
&T7 Initiate Remote Digital Loopback with self test (RDL + ST).
&T8 Initiate Analog LoopBack with self test (ALB+ST).
&V0 View current active settings.
&V1 View user profile 0 settings.
&V2 View user profile 1 settings.
&V3 View user profile 2 settings.
&V4 View user profile 3 settings.
&V5 View factory default settings.
&W0 Save current settings to user profile 0. (See also S35b6).
&W1 Save current settings to user profile 1.
&W2 Save current settings to user profile 2.
&W3 Save current settings to user profile 3.
+ &X0 Modem provides synchronous transmit clock signal (Internal clock to pin 15 of
EIA-232D) (Default).
&X1 Terminal provides synchronous transmit clock signal (External clock, from pin 24
of EIA-232D).
&X2 Receiving carrier provides synchronous transmit clock signal (Remote or Slave
clock, to pin 15 of EIA-232D).
&Y0 Destructive break, expedited. (Destructive break clears the buffer, expedited
Seitenansicht 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare