ZyXEL Communications U-1496 series Bedienungsanleitung PDF herunterladen (Seite 87)

OK: The DCE issues this result code if DCE accepts this command.

ERROR: The DCE issues this result code if <value> parameter is out of range.

AT+VBT?

DCE will return current beep duration setting, followed by the OK result code.

AT+VBT=?

DCE will return permitted values of beep duration. The response is:

1-255

with <CR><LF> between each line.

AT+VIP

This command causes the DCE to initialize all the voice parameters to the default settings

as follows:

Parameter: Value: see also

Compression method: 2-bit ADPCM +VSM

Silence threshold: 16 +VSD

Activity Timer: 7 sec.

Silence interval: 7 sec. +VSD

Ringback goes away timer: 7 sec. +VRA

Ringback never appeared timer: 5.7 sec. +VRN

Default beep tone duration: 1 sec. +VBT/+VTS

Result codes:

OK: The DCE issues this result code if DCE accepts this command.

ERROR: The DCE issues this result code if the DCE is not connected to at least one

voice I/O device.

AT+VLS=<device>

This command causes the DCE to select a voice I/O device.

The permitted <device> is as follows:

0: disconnect all I/O devices

2: Telco line

8: External Mic. (Connect a microphone or telephone set to the dial-up line RJ11

jack.)

16: Internal speaker

Result codes:

OK: The DCE issues this result code if DCE accepts this command.

ERROR: The DCE issues this result code if <device> is not permitted.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 107 108

Keine Kommentare

ZyXEL Communications U-1496 series Bedienungsanleitung Seite 87