
VES-1000 Series Ethernet Switch
4-2 General, Switch and IP Setup
Figure 4-2 Menu 2 - Switch Setup (VES-1008A)
Table 4-2 Menu 2 – Switch Setup
FIELD DESCRIPTION EXAMPLE
Ethernet Port 8 and Port
9 Trunking
Ethernet port trunking is disabled by default. Press [SPACE BAR],
select Yes, and then press [ENTER] to allow trunking (make sure the
remote switch also supports trunking).
Enable trunking (press [SPACE BAR], select Yes) only if you connect
both Ethernet ports to a single switch. (VES-1008A Ethernet ports 8
and 9 are equivalent to Ethernet ports 13 and 14 in the VES-1012).
No
Edit Spanning Tree
Protocol
Press [SPACE BAR] once to select Yes and then [ENTER] to display
Menu 2.1 - Spanning Tree Protocol Setup.
No
Edit GARP Timer Press [SPACE BAR] once to select Yes and then press [ENTER] to
go to Menu 2.2 — GARP Timer Setup.
No
VLAN Type Press [SPACE BAR] and then press [ENTER] to choose from 802.1Q
or Port-Based. See section 4.2.6 for more information on VLANs. To
enable IEEE 802.1Q on the VES-1000 Series switch, you must
configure it for the switch in this menu, menu 6 port submenu(s) and
menu 17 VLAN setup. Menu 17 is not applicable (N/A) if you choose
port-based VLANs for the switch in menu 2.
802.1Q
IGMP Snooping Press [SPACE BAR] once to select Enable and then press [ENTER].
Press [ENTER] again at the message “Press ENTER to Confirm…“ to
activate IGMP snooping on the device. See section 4.2.7 for more
information on IGMP snooping.
Disable
Edit QoS Support Press [SPACE BAR] once to select Yes and then press [ENTER to
go to Menu 2.3 — QoS Setup.
No
Aging Time Setting Enter a time from 0 to 1700 seconds. This is how long all dynamic
MAC addresses remain in the MAC Address Table before they age
out (and must be relearned).
300
Menu 2 - Switch Setup
Ethernet Port 9 and Port 10 Trunking= No
Edit Spanning Tree Protocol= No
Edit GARP Timer= No
VLAN Type= Port-Based
IGMP Snooping= Disable
Edit QoS Support= No
Aging Time Setting= 300
Port Mirroring= Disable
Snoop Port= N/A
Monitored Port= N/A
Broadcast Storm Control= 32 Frames
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Kommentare zu diesen Handbüchern