ZyXEL Communications STB-1001S Betriebsanweisung PDF herunterladen (Seite 35)

Chapter 2 The Menu System

STB-1001S User’s Guide

The following table describes the labels in this menu that were not already described in table 6.

2.3.4 The Advanced Setup: Firmware Upgrade Menu

Use this menu to get new firmware from the autoconfiguration server. You must be connected

to the network and have a valid autoconfiguration server address configured in the Advanced

Setup: Network menu’s ACS Server field (see Section 2.3.3 on page 32).

Select Firmware Upgrade from the column on the left of the screen. The following menu

displays.

Figure 13 The Firmware Upgrade Menu

If you want to get new firmware from the auto-configuration server, click Upgrade Now. The

STB contacts the autoconfiguration server and downloads the firmware.

If the following screen displays, the STB cannot reach the autoconfiguration server. Check the

settings in the Advanced Setup: Network menu (see Section 2.3.3 on page 32) and try again.

Figure 14 Firmware Upgrade Error

Table 8 The Network: PPPoE Menu

LABEL DESCRIPTION

Mode Select PPPoE to use a Point-to-Point Protocol over Ethernet

service.

User Name Enter the username for your PPPoE account.

Password Enter the password for your PPPoE account.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 136 137

Keine Kommentare

ZyXEL Communications STB-1001S Betriebsanweisung Seite 35