ZyXEL Communications G-220 v3 Betriebsanweisung Seite 29

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 125
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 28
ZyXEL G-220 v3 User’s Guide
Chapter 2 Tutorial 29
CHAPTER 2
Tutorial
The following sections show you how to join a wireless network using the ZyXEL utility, as in
the following diagrams. The wireless client is labeled C and the access point is labeled AP.
Figure 7 Infrastructure Network
There are three ways to connect the wireless client (the G-220 v3 in station mode) to a
network.
Configure nothing and leave the wireless client to automatically scan for and connect to
any available network that has no wireless security configured.
Manually connect to a network (see Section 2.1 on page 29).
Configure a profile to have the wireless client automatically connect to a specific network
or peer computer (see
Section 2.2 on page 31).
This chapter also includes a simple example of how to configure the G-220 v3 as an AP using
the ZyXEL utility. See
Section 2.3 on page 34 for more information.
2.1 Connecting to a Wireless LAN
This example illustrates how to manually connect your wireless client to an access point (AP)
which is configured for WPA-PSK security and connected to the Internet. Before you connect
to the access point, you must know its Service Set IDentity (SSID) and WPA-PSK pre-shared
key. In this example, the SSID is “SSID_Example3” and the pre-shared key is
“ThisismyWPA-PSKpre-sharedkey” in the AP.
After you install the ZyXEL utility and then insert the wireless client, follow the steps below
to connect to a network using the Site Survey screen.
1 Open the ZyXEL utility and click the Site Survey tab to open the screen as shown next.
Seitenansicht 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 124 125

Kommentare zu diesen Handbüchern

Keine Kommentare