ZyXEL Communications G-220 v3 Betriebsanweisung PDF herunterladen (Seite 76)

ZyXEL G-220 v3 User’s Guide

76 Chapter 5 Access Point Mode Configuration

5.1.2 Additional Setup Requirements

To bridge your wired and wireless network using the G-220 v3, the following requirements

must be met:

1 The G-220 v3 must be installed on a computer connected to the wired network.

2 Either bridge the two interfaces (wireless and wired) on the computer (using the

Configuration screen of the ZyXEL utility in Windows XP) or configure network

sharing (refer to

Appendix B on page 89 for an example).

3 Set the wireless station’s IP address to be dynamic if you want the wireless stations to

access the wired network or the Internet through the G-220 v3. Refer to

Appendix E on

page 111 for how to configure your computer’s IP address.

5.2 The Link Info Screen

Select the AP Mode check box and wait for about five seconds to display the screen as shown.

Figure 48 Access Point Mode: Link Info

The following table describes the labels in this screen.

Table 16 Access Point Mode: Link Info

LABEL DESCRIPTION

Status

SSID This field displays the name that identifies your G-220 v3 in the wireless LAN

network.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 124 125

Keine Kommentare

ZyXEL Communications G-220 v3 Betriebsanweisung Seite 76