ZyXEL Communications Prestige 623R-T Betriebsanweisung PDF herunterladen (Seite 7)

Prestige 623R-T ADSL Dual-link Router

ZyXEL Prestige 623R-T1 Quickstart Guide for IOL Broadband – Page 7

Connecting the Prestige 623 to your computer

n 3a: Using an Ethernet connection

This is the preferred method of connecting your computer to the Prestige 623 – if your computer has an

available Ethernet network port. If your computer does NOT have an Ethernet port available, you should skip

forward now to section 3b for details of how to use USB instead.

n Connecting the Ethernet cable

Connect the Ethernet cable supplied with the router between the Ethernet port on your desktop or notebook

PC or Macintosh and the port labelled “LAN 10/100M” on the rear of the Prestige 623. This port is “auto-

negotiating” – so it will automatically work with either a 10mb or 100mb computer network card – and “auto-

sensing” – so it can automatically adjust to either a straight-through or crossover Ethernet cable.

After you have connected the Ethernet cable, the 10M/100M light on the front of the router should light within

a few seconds, indicating that an Ethernet connection has been established.

Note: The Prestige 623 is configured to act as a “DHCP server”. This means it automatically

assigns an IP network address to your computer if it is configured to accept a “dynamic IP

address”. Since new computers are normally configured this way, most users need only plug the

ethernet cable into their PC – and then go straight to chapter 4 to complete the installation.

n Configuring the IP settings of your computer’s Ethernet port (if not set to dynamic already)

Your computer must have the TCP/IP networking protocol installed. TCP/IP will typically already be installed

on new computers using Windows NT, 2000 and XP, Macintosh OS 7 and later operating systems or on

computers that have previously been used to access the Internet.

If you are using an older operating system or a computer accessing the Internet for the first time, you may

need to add TCP/IP if it is not already installed. For instance, in Windows 95, 98 2nd Ed or ME this can be

done in the Network section of the Control Panel. (Your Windows CD may be required.)

Configuring IP settings in Windows 2000/NT/XP

1. In Windows XP, click Start, Control Panel.

In Windows 2000/NT, click Start, Settings, Control Panel.

2. In Windows XP, click Network Connections.

In Windows 2000/NT, click Network and Dial-up Connections.

3. Right-click Local Area Connection and then click Properties.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

ZyXEL Communications Prestige 623R-T Betriebsanweisung Seite 7