Zyxel-communications Omni TA128 Bedienungsanleitung PDF herunterladen (Seite 65)

All the above commands can be simplified by combining all of the

commands onto one line as follows:

AT&B20&E1&WZ0<Enter>

Dialing in V.120 mode

Finally, use the ATDn command to make the call (n is the phone

number you wish to dial). Once the connection is made, you

should see the following connect message.

CONNECT 115200/V120 56000/LAPD

This indicates that the connection is made with:

• DTE speed of 115,200bps.

• V.120 Protocol

• Data Speed of 56,000bps.

• Error Control LAPD.

Answering incoming calls

In most cases, there is no need to configure the TA128 to properly

answer calls. The TA128 is able to decide which protocol to use by

detecting the type of data that is coming in. All you need to do is

set S0 to greater than or equal to 1, so the TA128 will automatically

answer an incoming call. If S0=0, the DCE will simply report

“RING” to your terminal and sound a ring notification.

One exception to this is when the ISDN data call is carried through

Speech bearer. In this case, you would need to make an MSN entry

for the phone number that you are expecting the Data-over-

Speech-bearer call. Use AT&ZI2=n. Refer to the section entitled

“Data over Speech Channel” in Chapter 0 for details.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 172 173

Keine Kommentare

Zyxel-communications Omni TA128 Bedienungsanleitung Seite 65