
Chapter 4 ZyXEL Utility - Station Mode
NWD-211AN User’s Guide
75
4.7 Security Settings in Windows Vista
When you use the NWD-211AN in Windows Vista, the procedure for setting up
WPA, WPA2 and 802.1x security settings is different from that of other operating
systems (other security types are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same.
However, the procedure differs depending on whether you use PEAP (Protected
Extensible Authentication Protocol) or TLS (Transport Layer Security) encryption.
Consult your network administrator if you are unsure which type of encryption to
use.
See Section 4.7.1 on page 75 to use PEAP, or see Section 4.7.2 on page 76 to use
TLS.
Note: At the time of writing, TTLS (Tunneled TLS) is not available when using
Windows Vista.
4.7.1 Using PEAP in Vista
Take the following steps to set up WPA, WPA2 or 802.1x security using PEAP in
Windows Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
Section 4.4 on page 58), or configure a profile in the normal way (see Section 4.5
on page 65).
2 In the WPA, WPA2 or 802.1x security screen (see Section 4.4.1.3 on page 62
and Section 4.4.1.4 on page 63), select PEAP as the EAP Type. Note that the
Login Name and Password fields are greyed-out (not available).
3 Click Next.
4 In the Summary screen that appears, click Save.
5 A message similar to the following appears in the bottom-right of your screen.
Click it.
Figure 49 Vista Security: Additional Information Required
Kommentare zu diesen Handbüchern