ZyXEL Communications IES-708 Betriebsanweisung PDF herunterladen (Seite 113)

Chapter 13 xDSL Port Setup

IES-708-22A User’s Guide

113

13.9 PPVC Setup Screen

Use this screen to view and configure PPVCs.

To open this screen, click Basic Setting > xDSL Port Setup > PPVC Setup.

Figure 49 Basic Setting > xDSL Port Setup > PPVC Setup

The following table describes the labels in this screen.

Table 22 Basic Setting > xDSL Port Setup > PPVC Setup

LABEL DESCRIPTION

xDSL Port Setup Click xDSL Port Setup to go to the screen where you can configure DSL port

settings (see Section 13.5 on page 104).

VC Setup Click VC Setup to open the VC Setup screen where you can configure VC

settings for the DSL ports (see Section 13.7 on page 108).

Port Use this drop-down list box to select a port for which you wish to configure

settings.

Encap. Select the encapsulation type (llc or vc) for this PPVC.

VPI Type the Virtual Path Identifier for this PPVC.

VCI Type the Virtual Circuit Identifier for this PPVC. The IES-708-22A uses this PVC

channel internally. This PVC is not needed on the subscriber’s device. This PVC

cannot overlap with any existing PVCs on this port.

PVID Type a PVID (Port VLAN ID) to assign to untagged frames received on this

PPVC.

Priority Use the drop-down list box to select the priority value (0 to 7) to add to incoming

frames without a (IEEE 802.1p) priority tag.

Add / Modify Click Add / Modify to save PPVC settings for a port.

In order to change a port’s PPVC settings, just select the port from the Port

drop-down list box and then configure the settings you want. These settings

replace the port’s old settings when you click Add / Modify.

Clicking Add / Modify saves your changes to the IES-708-22A’s volatile

memory.

The IES-708-22A loses these changes if it is turned off or loses power, so use

the Config Save link on the navigation panel to save your changes to the non-

volatile memory when you are done configuring.

Cancel Click Cancel to start configuring the screen again.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 447 448

Keine Kommentare

ZyXEL Communications IES-708 Betriebsanweisung Seite 113