ZyXEL Communications IES-708 Betriebsanweisung PDF herunterladen (Seite 173)

100

101

Chapter 23 Spanning Tree Protocol

IES-708-22A User’s Guide

173

23.3 Spanning Tree Protocol Screen

To open this screen, click Advanced Application > Spanning Tree Protocol > STP Config.

Figure 82 Advanced Application > Spanning Tree Protocol > STP Config

The following table describes the labels in this screen.

Poll Interval(s)

Set Interval

The text box displays how often (in seconds) this screen refreshes. You may

change the refresh interval by typing a new number in the text box and then

clicking Set Interval.

Stop Click Stop to halt STP statistic polling.

Table 51 Advanced Application > Spanning Tree Protocol (continued)

LABEL DESCRIPTION

Table 52 Advanced Application > Spanning Tree Protocol > STP Config

LABEL DESCRIPTION

STP Status Click STP Status to display the IES-708-22A’s STP status (see Section 23.2 on

page 171).

Active Select this check box to turn on RSTP.

Note: It is recommended that you only use STP when you use the

IES-708-22A in standalone mode with a network topology

that has loops.

Bridge Priority Bridge priority is used in determining the root switch, root port and designated

port. The switch with the highest priority (lowest numeric value) becomes the

STP root switch. If all switches have the same priority, the switch with the lowest

MAC address will then become the root switch. The allowed range is 0 to

61440.

The lower the numeric value you assign, the higher the priority for this bridge.

Bridge Priority determines the root bridge, which in turn determines Hello Time,

Max Age and Forwarding Delay.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 447 448

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications IES-708 Betriebsanweisung Seite 173

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ZyXEL Communications IES-708