ZyXEL Communications IES-708 Betriebsanweisung PDF herunterladen (Seite 191)

Chapter 28 2684 Routed Mode

IES-708-22A User’s Guide

191

To open this screen, click Advanced Application > 2684 Routed Mode.

Figure 95 Advanced Application > 2684 Routed PVC

The following table describes the labels in this screen.

Table 60 Advanced Application > 2684 Routed PVC

LABEL DESCRIPTION

Routed Domain Click Routed Domain to open this screen where you can configure domains for

2684 routed mode traffic (see Section 28.3 on page 192).

RPVC ARP Proxy Click RPVC ARP Proxy to go to the screen where you can view the Address

Resolution Protocol table of IP addresses of CPE devices using 2684 routed

mode and configure how long the device is to store them (see Section 28.4 on

page 193).

Routed Gateway Click Routed Gateway to go to the screen where you can configure gateway

settings (see Section 28.5 on page 194).

Port Use this drop-down list box to select a port for which you wish to configure

settings.

Gateway IP Enter the IP address of the gateway to which you want to send the traffic that

the system receives from this PVC. Enter the IP address in dotted decimal

notation.

VPI Type the Virtual Path Identifier for this routed PVC.

VCI Type the Virtual Circuit Identifier for this routed PVC.

IP Enter the subscriber’s CPE WAN IP address in dotted decimal notation.

NetMask The bit number of the subnet mask of the subscriber’s WAN IP address. To find

the bit number, convert the subnet mask to binary and add all of the 1’s together.

Take “255.255.255.0” for example. 255 converts to eight 1’s in binary. There are

three 255’s, so add three eights together and you get the bit number (24).

Make sure that the routed PVC’s subnet does not include the IES-708-22A’s IP

address.

DS VC Profile Use the drop-down list box to select a VC profile to use for this channel’s

downstream traffic shaping.

US VC Profile Use the drop-down list box to select a VC profile to use for this channel’s

upstream traffic. The IES-708-22A does not perform upstream traffic policing if

you do not specify an upstream VC profile.

Add Click Add to save your changes to the IES-708-22A’s volatile memory.

The IES-708-22A loses these changes if it is turned off or loses power, so use

the Config Save link on the navigation panel to save your changes to the non-

volatile memory when you are done configuring.

Cancel Click Cancel to start configuring the screen again.

Index This field displays the number of the routed PVC.

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 447 448

Keine Kommentare

ZyXEL Communications IES-708 Betriebsanweisung Seite 191