
Chapter 53 DSL Commands
IES-708-22A User’s Guide
336
Information obtained prior to training to steady state transition will not be valid or will be old
information.
53.2.3 DSL Port Lineinfo Command
Syntax:
ras> statistics shdsl lineinfo <portlist>
where
This command displays the information that is reported by the remote device in an Inventory
Response message. If information is not provided, the field is blank.
An example is shown next.
The following table explains these counters.
actual rate This is the rate (in Kbps) at which the port has been sending and receiving data.
noise margin This is the DSL line’s noise margin measured in decibels (dB).
attenuation This is the reduction in amplitude of the DSL signals, measured in decibels (dB).
linkup count This is the number of times the IES-708-22A has established a link on this port.
Table 94 DSL Port Linerate Command Counters (continued)
LABEL DESCRIPTION
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> statistics shdsl lineinfo 1
[port 1]
unit STUC
shdsl version : 10
vendor list :
vendor issue :
vendor id : IFX
vendor model : SOC16-SDFE4
vendor serial : 003
vendor other :
software version : 091000
equipment code :
Table 95 DSL Port Lineinfo Command Counters
LABEL DESCRIPTION
unit This field displays the role of the remote device in the connection.
shdsl version This field displays the version of the HDSL2/SHDSL standard implemented.
vendor list This field displays the vendor list number.
vendor issue This field displays the vendor issue number.
vendor id This field displays the vendor ID.
Kommentare zu diesen Handbüchern