ZyXEL Communications Omni 288S Bedienungsanleitung PDF herunterladen (Seite 15)

novaPro32 Routel

Routel set-up

7000991003 Q2

Sauter Systems

Dial string 1

- The dial string for your modem, normally:-

"ATDT[phone number]<"

(Where the ‘<’ character has to follow the string, it causes the Routel to send the

carriage return.)

(The dots indicate the available number of characters for this string)

(Special characters within the phone number: ‘,’ makes the modem wait for 1 or 2

seconds, ‘w’ makes the modem wait for the dial tone before dialling. Refer to your

modem manual for more information.)

Æ Please also refer to Special Hints below regarding the modem dial-up strings.

Initialisation string

- This string is sent to the modem when the Routel receives a positive flank of the

DSR signal (when the Routel or the modem is started or the cable is re-connected).

N.B.: The command is sent to the modem only if the EYZ291 is set to Routel mode

(when the Routel switch is set).

- You have to enter the string that sets the modem to the proper mode of operation.

Normally, the string which loads the factory default settings followed by the

command for ‘Auto Answer’ is fine. The following commands have been tested:-

E.g. ZyXel: "AT&FS0=1<"

3COM: "AT&F1S0=1<"

Olitec: "AT&FS0=1&WZ<"

(Where the ‘<’ character has to follow the string. It causes the Routel to send the

carriage return.)

(The dots indicate the available number of characters for this string.)

Æ Please also refer to Special Hints below regarding the modem Init strings.

Notify

- PC access: Causes the Routel to call the Supervision PC after an access from a

remote-access PC (3

-party access).

- AS supervision: Causes the Routel to call the Supervision PC after detecting a

change in the number of ASs active on the AS network concerned, or if the AS

network is no longer available.

(Æ Concerns the AS supervision by the Routel. This message is not yet interpreted

by novaPro32. This ‘AS supervision by 291’ feature will be included in V4.1)

- Power on: Causes the Routel to call the Supervision PC after power has been

restored to the Routel.

Dial Sequence

Click the ‘Dial Sequence...’ button to open the ‘Dial Sequence’ menu:-

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Keine Kommentare

ZyXEL Communications Omni 288S Bedienungsanleitung Seite 15