ZyXEL Communications VES-1012 - Betriebsanweisung PDF herunterladen (Seite 111)

VES-1000 Series Ethernet Switch

Introducing the SMT 14-5

Figure 14-5 Menu 23.1 - System Password

3. Enter your new system password and press [ENTER].

4. Re-type your new system password for confirmation and press [ENTER].

14.6.1 Resetting the VES

If you forget your password or cannot access the VES, you will need to reload the factory-default configuration file.

Uploading this configuration file replaces the current configuration file with the factory-default configuration file.

This means that you will lose all configurations that you had previously and the speed of the console port will be

reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password

will also be reset to “1234” and the IP address to 192.168.1.1.

To obtain the default configuration file, download it from the ZyXEL FTP site, unzip it and save it in a folder. Turn

the VES off and then on to begin a session. When you turn on the VES again you will see the initial screen. When

you see the message “Press any key to enter Debug Mode within 3 seconds” press any key to enter debug mode.

To upload the configuration file, do the following:

1. Type atlc after the Enter Debug Mode message.

2. Wait for the Starting XMODEM upload message before activating XMODEM upload on your terminal.

3. After a successful firmware upload, type atgo to restart the VES.

The VES is now reinitialized with a default configuration file including the default password of “1234”.

Please see the section about uploading the default configuration file for information on uploading the default

configuration file using CI commands.

Menu 23 - System Password

Old Password= ?

New Password= ?

Retype to confirm= ?

Enter here to CONFIRM or ESC to CANCEL:

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 226 227

Keine Kommentare

ZyXEL Communications VES-1012 - Betriebsanweisung Seite 111