
VES-1000 Series Ethernet Switch
VDSL-Related Commands 23-11
Table 23-7 Ethernet Speed Parameters
SPEED INDEX NUMBER SPEED/FLOW CONTROL
0 Auto Negotiation
1 10 Mbits/s, Half Duplex
2 10 Mbits/s, Full Duplex
3 100Mbits/s, Half Duplex
4 100Mbits/s, Full Duplex
23.3.4 Enet Fctrl Command
vdsl enet fctrl chan-id (lt|nt) [on|off]
Type this command to set the Ethernet port flow control or show the Ethernet port flow control status (without
“on” or “off”). By default, flow control is on for full duplex Ethernet connections and off for half duplex Ethernet
connections.
Figure 23-10 Ethernet Flow Control
23.3.5 Enet Monitor Command
vdsl enet monitor chan-id [on|off]
When this flag is on this command automatically displays the VES (and the subscriber’s VDSL modem’s Ethernet
statistics if the link is up) every five seconds. Enter the command without “on” or “off” to just show the Ethernet
monitor status.
Figure 23-11 Ethernet Monitor Status
ves-100>vdsl enet monitor 2
enet monitor flag: off
ves-100>vdsl enet fctrl 2
enet flow control(LT): on
Kommentare zu diesen Handbüchern