ZyXEL Communications ZyWALL 70 Technical Information PDF herunterladen (Seite 22)

ZyWALL 1050 Support Notes

Authentication :MD5

Key Group :DH1

Authentication :MD5

Key Group :DH1

Phase2

Encapsulation: Tunnel

Active Protocol: ESP

Encryption: DES

Authentication: SHA1

Perfect Forward Secrecy (PFS): None

Phase2

Encapsulation: Tunnel

Active Protocol: ESP

Encryption: DES

Authentication: SHA1

Perfect Forward Secrecy (PFS): None

1) Configure the ZyWALL1050 ‘s VPN gateway and VPN connection as on the list. Also,

remember to configure the policy route for the VPN traffic routing. Refer to the previous

scenario or user guide to find help on setting the ZyWALL1050 VPN.

2) Login to the FortiGate GUI and switch to System > Network > Interface and set the wan1

interface to 167.35.4.3 and internal interface to 192.168.2.1/255.255.255.0.

Note: About the detail interface settings, refer to FortiGate user guide.

3) Switch to System > VPN > IPSEC and select the Auto Key (IKE) tab and click the Create

Phase 1 button. This will open a new page for VPN phase1 setup.

4) Fill-in the VPN phase1 setting according to the table listed. We don’t have to setup the ID

type and content because the FortiGate accepts any peer ID. Make sure both the pre-shares

key and proposal are the same as in the ZyWALL1050.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 297 298

Keine Kommentare

ZyXEL Communications ZyWALL 70 Technical Information Seite 22