ZyXEL Communications MES-2110 Betriebsanweisung PDF herunterladen (Seite 104)

Chapter 15 Link Aggregation

MES-2110 User’s Guide

104

The following table describes the labels in this screen.

15.5 Link Aggregation Control Protocol

Click Configuration > Trunk Config > LACP Configuration to display the

screen shown next. See Section 15.2 on page 101 for more information on

dynamic link aggregation.

Figure 51 Configuration > Trunk Config > LACP Configuration

The following table describes the labels in this screen.

Table 42 Configuration > Trunk Config > Aggregator Setting

LABEL DESCRIPTION

Group This is the trunk group index number.

The Switch supports up to four trunk groups for 100Mbps ports and up to

two trunk groups for Gigabit ports. 100Mbps ports and Gigabit ports cannot

be in the same group.

Members Select the port(s) that belong to a trunk group.

For Groups 1 to 4, you can select up to four port members for each group.

For Group 5, you can select the two Gigabit ports as the members.

LACP Use this to enable or disable LACP port trunking.

Undo Click this to restore your last saved settings.

Apply Click this to save your changes.

Table 43 Configuration > Trunk Config > LACP Configuration

LABEL DESCRIPTION

Port State

Activity

Select the port to enable Link Aggregation Control Protocol (LACP).

Hash-mode Use this to specify the outgoing traffic distribution type.

Select Lookup to distribute frames based on the destination MAC address.

Select Xor to distribute frames based on the last 3 bits of the source MAC

address and the trunk mask load balancing table.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 183 184

Keine Kommentare

ZyXEL Communications MES-2110 Betriebsanweisung Seite 104