ZyXEL Communications MES-2110 Betriebsanweisung PDF herunterladen (Seite 59)

MES-2110 User’s Guide

CHAPTER 7

Loop Detection

7.1 Overview

Loop detection allows you to configure the Switch to shut down a port if it detects

that frames sent out on that port loop back to the Switch.

Loop detection is designed to handle loop problems on the edge of your network.

This can occur when a port is connected to a Switch that is in a loop state. Loop

state occurs as a result of human error. It happens when two ports on a switch are

connected with the same cable. When a switch in loop state sends out broadcast

messages the messages loop back to the switch and are re-broadcast again and

again causing a broadcast storm.

If a switch (not in loop state) connects to a switch in loop state, then it will be

affected by the switch in loop state in the following way:

• It will receive broadcast messages sent out from the switch in loop state.

• It will receive its own broadcast messages that it sends out as they loop back. It

will then re-broadcast those messages again.

The following figure shows port N on switch A connected to switch B. Switch B is

in loop state. When broadcast or multicast frames leave port N and reach switch

B, they are sent back to port N on A as they are rebroadcast from B.

Figure 26 Switch in Loop State

The loop detection feature checks to see if a loop detection enabled port is

connected to a switch in loop state. This is accomplished by periodically sending a

probe frame and seeing if the frame returns on the same port. If this is the case,

the Switch will shut down the port connected to the switch in loop state.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 183 184

Keine Kommentare

ZyXEL Communications MES-2110 Betriebsanweisung Seite 59