ZyXEL Communications GS3700 Series Betriebsanweisung Seite 117

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 416
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 116
Chapter 11 Spanning Tree Protocol
GS3700/XGS3700 Series User’s Guide
117
11.2 Spanning Tree Protocol Status Screen
Click Advanced Application > Spanning Tree Protocol to see the screen as shown.
Figure 67 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section for
each STP mode. Click Configuration to activate one of the STP standards on the Switch.
11.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch.
Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 68 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 42 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning
Tree. See Section 11.1 on page 112 for background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Seitenansicht 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 415 416

Kommentare zu diesen Handbüchern

Keine Kommentare