ZyXEL Communications GS3700 Series Betriebsanweisung PDF herunterladen (Seite 217)

Chapter 23 AAA

GS3700/XGS3700 Series User’s Guide

217

23.2.4 Vendor Specific Attribute

RFC 2865 standard specifies a method for sending vendor-specific information between a RADIUS

server and a network access device (for example, the Switch). A company can create Vendor

Specific Attributes (VSAs) to expand the functionality of a RADIUS server.

The Switch supports VSAs that allow you to perform the following actions based on user

authentication:

• Limit bandwidth on incoming or outgoing traffic for the port the user connects to.

• Assign account privilege levels (see the CLI Reference Guide for more information on account

privilege levels) for the authenticated user.

The VSAs are composed of the following:

• Vendor-ID: An identification number assigned to the company by the IANA (Internet Assigned

Numbers Authority). ZyXEL’s vendor ID is 890.

• Vendor-Type: A vendor specified attribute, identifying the setting you want to modify.

• Vendor-data: A value you want to assign to the setting.

Note: Refer to the documentation that comes with your RADIUS server on how to

configure VSAs for users authenticating via the RADIUS server.

Mode The Switch supports two modes of recording login events. Select:

• start-stop - to have the Switch send information to the accounting server when a

user begins a session, during a user’s session (if it lasts past the Update Period),

and when a user ends a session.

• stop-only - to have the Switch send information to the accounting server only when

a user ends a session.

Method Select whether you want to use RADIUS or TACACS+ for accounting of specific types of

events.

TACACS+ is the only method for recording Commands type of event.

Privilege This field is only configurable for Commands type of event. Select the threshold

command privilege level for which the Switch should send accounting information. The

Switch will send accounting information when commands at the level you specify and

higher are executed on the Switch.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top navigation

panel to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Table 98 Advanced Application > AAA > AAA Setup (continued)

LABEL DESCRIPTION

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 415 416

Keine Kommentare

ZyXEL Communications GS3700 Series Betriebsanweisung Seite 217