ZyXEL Communications GS3700 Series Betriebsanweisung Seite 218

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 416
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 217
Chapter 23 AAA
GS3700/XGS3700 Series User’s Guide
218
The following table describes the VSAs supported on the Switch. Note that these attributes only
work when you enable authorization (see Section 23.2.3 on page 215).
23.2.5 Tunnel Protocol Attribute
You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS server
documentation) to assign a port on the Switch to a VLAN based on IEEE 802.1x authentication. The
port VLAN settings are fixed and untagged. This will also set the port’s VID. The following table
describes the values you need to configure. Note that these attributes only work when you enable
authorization (see Section 23.2.3 on page 215).
23.3 Supported RADIUS Attributes
Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define specific
authentication, and accounting elements in a user profile, which is stored on the RADIUS server.
This section lists the RADIUS attributes supported by the Switch.
Table 99 Supported VSAs
FUNCTION ATTRIBUTE
Ingress Bandwidth
Assignment
Vendor-Id = 890
Vendor-Type = 1
Vendor-data =
ingress rate (Kbps in decimal format)
Egress Bandwidth
Assignment
Vendor-Id = 890
Vendor-Type = 2
Vendor-data = egress rate (Kbps in decimal format)
Privilege Assignment
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
Vendor-ID = 9 (CISCO)
Vendor-Type = 1 (CISCO-AVPAIR)
Vendor-Data = "shell:priv-lvl=N"
where N is a privilege level (from 0 to 14).
Note: If you set the privilege level of a login account differently on the RADIUS server(s)
and the Switch, the user is assigned a privilege level from the database (RADIUS
or local) the Switch uses first for user authentication.
Table 100 Supported Tunnel Protocol Attribute
FUNCTION ATTRIBUTE
VLAN Assignment
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
VLAN ID
Note: You must also create a VLAN with the specified VID on the Switch.
Note: The bolded values in this table are fixed values as defined in RFC 3580.
Seitenansicht 217
1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 415 416

Kommentare zu diesen Handbüchern

Keine Kommentare