ZyXEL Communications GS3700 Series Betriebsanweisung PDF herunterladen (Seite 204)

Chapter 22 Multicast

GS3700/XGS3700 Series User’s Guide

204

22.6.1 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data sent to

this multicast group.

Use this screen to configure MVR IP multicast group address(es). Click the Group Configuration

link in the MVR screen.

* Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row

first to set the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Source Port Select this option to set this port as the MVR source port that sends and receives multicast

traffic. All source ports must belong to a single multicast VLAN.

Receiver Port Select this option to set this port as a receiver port that only receives multicast traffic.

None Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent

or received on this port.

Tagging Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames

transmitted.

Add Click this to create a new entry or to update an existing one.

This saves your changes to the Switch’s run-time memory. The Switch loses these changes

if it is turned off or loses power, so use the Save link on the top navigation panel to save

your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

VLAN This field displays the multicast VLAN ID. Click on an index number to change the settings.

Active This field displays whether the multicast group is enabled or not.

Name This field displays the descriptive name for this setting.

Mode This field displays the MVR mode.

Source Port This field displays the source port number(s).

Receiver Port This field displays the receiver port number(s).

802.1p This field displays the priority level.

Delete To delete a multicast VLAN(s), select the rule(s) that you want to remove in the Delete

column, then click the Delete button.

Cancel Click Cancel to clear the Delete check boxes.

Table 93 Advanced Application > Multicast > Multicast Setting > MVR (continued)

LABEL DESCRIPTION

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 415 416

Keine Kommentare

ZyXEL Communications GS3700 Series Betriebsanweisung Seite 204