ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung PDF herunterladen (Seite 292)

Chapter 35 System

ZyWALL (ZLD) CLI Reference Guide

292

35.6.2 DNS Commands

The following table identifies the values required for many of these commands. Other input

values are discussed with the corresponding commands.

The following table describes the commands available for DNS. You must use the

configure

terminal

command to enter the configuration mode before you can use these commands.

Table 163 Input Values for General DNS Commands

LABEL DESCRIPTION

address_object The name of the IP address (group) object. You may use 1-31 alphanumeric

characters, underscores(

_), or dashes (-), but the first character cannot be a

number. This value is case-sensitive.

interface_name The name of the interface.

Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 - N,

where N equals the highest numbered Ethernet interface for your ZyWALL

model.

The ZyWALL USG 100 and 200 models use a name such as wan1, wan2,

opt, lan1, ext-wlan, or dmz.

virtual interface on top of Ethernet interface: add a colon (:) and the number of

the virtual interface. For example: gex:y, x = 1 - N, y = 1 - 4

VLAN interface: vlanx, x = 0 - 4094

virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 12

bridge interface: brx, x = 0 - N, where N depends on the number of bridge

interfaces your ZyWALL model supports.

virtual interface on top of bridge interface: brx:y, x = the number of the bridge

interface, y = 1 - 4

PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of

PPPoE/PPTP interfaces your ZyWALL model supports.

Table 164 Command Summary: DNS

COMMAND DESCRIPTION

[no] ip dns server a-record fqdn w.x.y.z Sets an A record that specifies the mapping of a

fully qualified domain name (FQDN) to an IP

address. The no command deletes an A record.

ip dns server -flush Clears the DNS .

[no] ip dns server mx-record domain_name

{w.x.y.z|fqdn}

Sets a MX record that specifies a mail server that

is responsible for handling the mail for a

particular domain. The

no command deletes a

MX record.

ip dns server rule {<1..32>|append|insert

<1..32>} access-group {ALL|address_object} zone

{ALL|address_object} action {accept|deny}

Sets a service control rule for DNS requests.

ip dns server rule move <1..32> to <1..32> Changes the number of a service control rule.

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 385 386

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung Seite 292

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1