ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung PDF herunterladen (Seite 303)

Chapter 36 System Remote Management

ZyWALL (ZLD) CLI Reference Guide

303

36.8.1 Supported MIBs

The ZyWALL supports MIB II that is defined in RFC-1213 and RFC-1215. The ZyWALL also

supports private MIBs (zywall.mib and zyxel-zywall-ZLD-Common.mib) to collect

information about CPU and memory usage and VPN total throughput. The focus of the MIBs

is to let administrators collect statistical data and monitor status and performance. You can

download the ZyWALL’s MIBs from www.zyxel.com.

36.8.2 SNMP Traps

The ZyWALL will send traps to the SNMP manager when any one of the following events

occurs:

36.8.3 SNMP Commands

The following table describes the commands available for SNMP. You must use the

configure terminal command to enter the configuration mode before you can use these

commands.

Table 170 SNMP Traps

OBJECT LABEL OBJECT ID DESCRIPTION

Cold Start 1.3.6.1.6.3.1.1.5.1 This trap is sent when the ZyWALL is turned on or an

agent restarts.

linkDown 1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link is down.

linkUp 1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link is up.

authenticationFailure 1.3.6.1.6.3.1.1.5.5 This trap is sent when an SNMP request comes from

non-authenticated hosts.

Table 171 Command Summary: SNMP

COMMAND DESCRIPTION

[no] snmp-server Allows SNMP access to the ZyWALL. The no

command disables SNMP access to the

ZyWALL.

[no] snmp-server community community_string

{ro|rw}

Enters up to 64 characters to set the password

for read-only (ro) or read-write (rw) access. The

no command resets the password for read-only

(

ro) or read-write (rw) access to the default.

[no] snmp-server contact description Sets the contact information (of up to 60

characters) for the person in charge of the

ZyWALL. The

no command removes the contact

information for the person in charge of the

ZyWALL.

[no] snmp-server enable {informs|traps} Enables all SNMP notifications (informs or traps).

The

no command disables all SNMP

notifications (informs or traps).

[no] snmp-server host {w.x.y.z}

[community_string]

Sets the IP address of the host that receives the

SNMP notifications. The no command removes

the host that receives the SNMP notifications.

[no] snmp-server location description Sets the geographic location (of up to 60

characters) for the ZyWALL. The

no command

removes the geographic location for the

ZyWALL.

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 385 386

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung Seite 303

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1