ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung PDF herunterladen (Seite 77)

Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

6.7.2.1 WLAN Interface Commands Example

This example configures WLAN AP interface 2 for slot 1 to use SSID WLAN_test, WPA

security modes with a pre-shared key of 12345678, IP address 1.1.1.1, netmask 255.255.255.0,

and a gateway IP address of 1.2.3.4 with a priority of 10.

6.7.3 WLAN MAC Filter Commands

Use these commands to give specific wireless clients exclusive access to the ZyWALL (allow

association) or block specific devices from accessing the ZyWALL (deny association) based

on the devices’ MAC addresses.

station-limit <1..255> Sets the highest number of wireless clients that are allowed to

connect to the wireless interface at the same time.

wep-key <1..4> key There are four data encryption keys to secure your data from

eavesdropping by unauthorized wireless users. The values

for the keys must be set up exactly the same on the access

points as they are on the wireless stations.

If you set WEP encryption to use a 64 bit key using the

security mode and security wep 64 commands, type

any 5 characters (ASCII string) or 5 pairs of hexadecimal

characters ("0-9", "A-F") preceded by 0x for each key.

If you set WEP encryption to use a 128 bit key using the

security mode and security wep 128 commands, type

13 characters (ASCII string) or 13 pairs of hexadecimal

characters ("0-9", "A-F") preceded by 0x for each key.

Table 31 WLAN Interface Commands (continued)

COMMAND DESCRIPTION

Router(config)# interface wlan-1-2

Router(config-if-wlan)# ssid WLAN_test

Router(config-if-wlan)# security wpa tkip psk key 12345678

Router(config-if-wlan)# security mode wpa

Router(config-if-wlan)# ip address 1.1.1.1 255.255.255.0

Router(config-if-wlan)# ip gateway 1.2.3.4 metric 10

Router(config-if-wlan)# exit

Table 32 WLAN General Commands

COMMAND DESCRIPTION

[no] wlan mac-filter mac_address

[description description]

Specifies the MAC address (in XX:XX:XX:XX:XX:XX format)

of the wireless station that is to be allowed or denied access

to the ZyWALL. The no command removes the entry.

description: You can use alphanumeric and

()+/

:=?!*#@$_%- characters, and it can be up to 60

characters long.

[no] wlan mac-filter activate Turns the MAC address filter on or off.

wlan mac-filter associate <allow |

deny>

Defines the filter action for the list of MAC addresses in the

MAC address filter table. Allow permits them to access to the

ZyWALL, MAC addresses not listed will be blocked.

Deny blocks the listed addresses from accessing the router,

MAC addresses not listed will be allowed to access the router.

show wlan mac-filter status Displays the MAC filter’s activation and association settings.

show wlan mac-filter Displays the WLAN MAC filter entries.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 385 386

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung Seite 77

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1