ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung PDF herunterladen (Seite 64)

Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

6.3.2 Port Grouping Commands

This section covers commands that are specific to port grouping.

" In CLI, representative interfaces are also called representative ports.

type {internal|external|general} Sets which type of network you will connect this

interface. The ZyWALL automatically adds default

route and SNAT settings for traffic it routes from

internal interfaces to external interfaces; for

example LAN to WAN traffic.

internal: Set this to connect to a local network.

Other corresponding configuration options: DHCP

server and DHCP relay. The ZyWALL automatically

adds default SNAT settings for traffic flowing from

this interface to an external interface.

external: Set this to connect to an external

network (like the Internet). The ZyWALL

automatically adds this interface to the default

WAN trunk.

general: Set this if you want to manually

configure a policy route to add routing and SNAT

settings for the interface.

no use-defined-mac Has the interface use its default MAC address.

use-defined-mac Has the interface use a MAC address that you

specify.

Table 23 interface Commands: MAC Setting (continued)

COMMAND DESCRIPTION

Table 24 Basic Interface Setting Commands

COMMAND DESCRIPTION

show port-grouping Displays which physical ports are assigned to each

representative interface.

port-grouping representative_interface port

<1..x>

Adds the specified physical port to the specified

representative interface.

representative_interface: gex in a ZyWALL

USG 300 or above.

A dmz, ext-wlan, or lan1 interface in a ZyWALL

USG 100 or 200.

<1..x> where x equals the highest numbered port

for your ZyWALL model.

no port <1..x> Removes the specified physical port from its

current representative interface and adds it to its

default representative interface (for example, port x

--> gex).

port status Port<1..x> Enters a sub-command mode to configure the

specified port’s settings.

[no] duplex <full | half> Sets the port’s duplex mode. The no command

returns the default setting.

exit Leaves the sub-command mode.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 385 386

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Betriebsanweisung Seite 64

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1