ZyXEL Communications IES-1248-51 Betriebsanweisung PDF herunterladen (Seite 149)

100

101

Chapter 17 xDSL Profiles Setup

IES-1248-51V User’s Guide

149

The following table describes the labels in this screen.

Table 28 Alarm Profile

LABEL DESCRIPTION

xDSL Profile Click xDSL Profile to open the Port Profile screen (see Section 17.1

on page 139). Use the Port Profile screen to configure profiles of

ADSL port settings (such as the transfer rate, interleave delay and

signal to noise ratio settings).

VC Profile Click VC Profile to open the VC Profile screen where you can

configure virtual channel profiles (see Section 17.5 on page 146).

Name This field is read-only if you click Modify to edit a port profile. Type a

name to identify the alarm profile (you cannot change the name of

the DEFVAL profile). You can use up to 31 ASCII characters; spaces

are not allowed.

Add Click Add to save your changes to the IES-1248-51V’s volatile

memory. The IES-1248-51V loses these changes if it is turned off or

loses power, so use the Config Save link on the navigation panel to

save your changes to the non-volatile memory when you are done

configuring.

Cancel Click Cancel to start configuring the screen again.

Threshold Specify limits for the individual performance counters. The IES-1248-

51V sends an alarm trap and generates a syslog entry when one of

these thresholds is exceeded. A value of 0 disables the alarm

threshold.

ATU-C These fields are for traffic coming from the subscriber’s device to the

IES-1248-51V.

ATU-R These fields are for traffic going from the IES-1248-51V to the

subscriber’s device.

15 Min LOF This field sets the limit for the number of Loss Of Frame seconds that

are permitted to occur within 15 minutes.

15 Min LOS This field sets the limit for the number of Loss Of Signal seconds that

are permitted to occur within 15 minutes.

15 Min LOL This field sets limit for the number of Loss Of Link seconds that are

permitted to occur within 15 minutes.

15 Min LPR This field sets the limit for the number of Loss of Power (on the ATUR)

seconds that are permitted to occur within 15 minutes.

15 Min ES

(seconds)

This field sets the limit for the number of Errored Seconds that are

permitted to occur within 15 minutes.

15 Min SES

(seconds)

This field sets the limit for the number of Severely Errored seconds

that are permitted to occur within 15 minutes.

15 Min UAS

(seconds)

This field sets the limit for the number of UnAvailable seconds that

are permitted to occur within 15 minutes.

15 Min Failed Fast

Retrain

This field sets the limit for the number of failed fast retrains that are

permitted within 15 minutes.

Init Failure Trap Select Active to trigger an alarm for an initialization failure trap.

Fast Rate Up

(bps)

Specify a rate in kilobits per second (kbps). If a fast mode

connection’s upstream transmission rate increases by more than this

number, then a trap is sent.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 653 654

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL Communications IES-1248-51 Betriebsanweisung Seite 149

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ZyXEL Communications IES-1248-51