
Chapter 52 System Commands
IES-1248-51V User’s Guide
379
52.1.1 Idle Timeout Set Command Example
By default, the IES-1248-51V automatically logs you out of the management
interface after five minutes of inactivity. Use the sys stdio set command to
extend the idle timeout. The following example extends the idle timeout to 120
minutes.
sys syslog show Displays the syslog settings. M/L
sys time set <hh> [<mm> [ss]] Sets the system’s time. H/H
sys time show Displays the system’s current time. L/L
sys timeserver set <daytime>
<ip-address> [nosync]
Sets the time service protocol and the time
server’s IP address.
H/H
sys timeserver set <none> Sets the system to not use a time server. H/H
sys timeserver set <time|ntp>
<ip> <utc[<+|->0100~1200]>
[nosync]
Sets the time service protocol, time server’s
IP address and the device’s time zone.
H/H
sys timeserver show Displays the system’s time server. M/L
sys timeserver sync Retrieves the date and time from the time
server.
H/H
sys user auth
<local|radius|landr>
Sets the authentication method. H/H
sys user delete <name> Removes the specified user name of multi-
login.
H/H
sys user disable <name> Turns off the specified user name of multi-
login.
H/H
sys user enable <name> Turns on the specified user name of multi-
login.
H/H
sys user online Displays online user info. M/
~
sys user server <ip-address>
<port> <secret>
[high|middle|low|deny]
Set remote authentication server’s IP address
and secret.
H/H
sys user set <username>
<password> <high|middle|low>
Creates or edits the password and privilege
level of the specified user name.
H/H
sys user show Displays the authentication mode, RADIUS
server settings and user info.
M/L
sys wdog set <msec> Sets the watchdog count. 0 turns the
watchdog off.
H/
~
sys wdog show Displays the current watchdog firmware
protection feature status and timer.
H/
~
Table 134 System Commands (continued)
COMMAND DESCRIPTION P
ras> sys stdio set 120
ras>
Kommentare zu diesen Handbüchern