
Chapter 62 IP Bridge Commands
IES-1248-51V User’s Guide
454
62.2.1 IP Bridge Domain Show Command Example
An example is shown next.
The output values correspond to the input values of other IP bridge domain
commands.
62.2.2 IP Bridge Domain DHCP VLAN Enable Command
Example
In the following example, domain “example3” has its DHCP server in VLAN 401.
adsl ipbpvc domain dhcpvlan
disable <domain-name>
This setting has no effect on DHCP packets that come from
VLANs where the IES-1248-51V’s DHCP relay settings are
active. (See Chapter 54 on page 393. The DHCP relay
settings take precedence over the IP bridge DHCP VLAN
setting.)
This command specifies that there is no DHCP server for
the domain, in which case the IES-1248-51V does not
change the source MAC address in DHCP packets.
The IES-1248-51V still adds whatever Option 82
information is specified for the VLAN in the DHCP relay
settings. (See Chapter 54 on page 393.)
H/H
adsl ipbpvc domain vlan
<domain-name> <vlan-id>
join|leave
This command adds the specified VLAN to (join) or
removes the specified VLAN (leave) from the specified
domain. VLANs in IP bridges share the same VLAN space
as regular VLANs, so VLANs in IP bridges must have
different VLAN IDs than regular VLANs. Use the regular
VLAN commands to configure the VLAN (see Chapter 54
on page 403).
You have to delete every IP bridge setting (including DHCP
VLAN) that uses the selected VLAN before you can remove
it from the domain.
H/H
Table 174 IP Bridge Domain Commands
COMMAND DESCRIPTION P
ras> adsl ipbpvc domain show example1
Domain Name:example1
DHCP VLAN: 200
VLAN
----+----+----+----+----+----+----+----+
200 210 220 240 502
ras> adsl ipbpvc domain dhcpvlan enable example3 401
Kommentare zu diesen Handbüchern