
IES-1248-51V User’s Guide
467
CHAPTER 63
SNMP Commands
This chapter covers commands for configuring the IES-1248-51V’s Simple
Network Management Protocol (SNMP) settings.
63.1 SNMP Commands
The following table describes common required values in SNMP commands. Other
values are discussed with the corresponding commands.
The following is a list of the SNMP commands.
Table 181 SNMP Commands Input Values
LABEL DESCRIPTION
community A password.
Table 182 SNMP Commands
COMMAND DESCRIPTION P
sys snmp getcommunity
<community>
Sets the password for the incoming Get- and GetNext-
requests from the management station.
H/H
sys snmp setcommunity
<community>
Sets the password for the incoming Set- requests from the
management station.
H/H
sys snmp trusthost <ip-
address>
Specifies the IP address a trusted host.
If you enter a specific IP address, the IES-1248-51V will
only respond to SNMP messages from this address. You
can use the sys client set command to specify
additional IP addresses, if necessary. See Table 134 on
page 377 for more information about this command.
If you specify 0.0.0.0, the IES-1248-51V responds to all
SNMP messages it receives, regardless of the settings for
the sys client set command.
H/H
sys snmp trapcommunity
<community>
Sets the password sent with each trap to the SNMP
manager.
H/H
Kommentare zu diesen Handbüchern