
Chapter 66 Virtual Channel Commands
IES-1248-51V User’s Guide
524
LAN computer’s IP address is 10.10.10.1. This includes the CPE device’s LAN IP
addresses and the IP addresses of the LAN computers.
Figure 231 2684 Routed Mode Example
Note the following.
• The CPE device’s WAN IP (192.168.10.200 in this example) must be in the same
subnet as the gateway’s IP address (192.168.10.102 in this example).
• The IES-1248-51V's management IP address can be any IP address, it doesn't
have any relationship to the WAN IP address or routed gateway IP address.
• The IES-1248-51V’s management IP address should not be in the same subnet
as the one defined by the WAN IP address and netmask of the subscriber’s
device. It is suggested that you set the netmask of the subscriber’s WAN IP
address to 32 to avoid this problem.
• The IES-1248-51V's management IP address should not be in the same subnet
range of any RPVC and RPVC domain. It will make the IES-1248-51V confused if
the IES-1248-51V receives a packet with this IP as destination IP.
• The IES-1248-51V’s management IP address also should not be in the same
subnet as the one defined by the LAN IP address and netmask of the
subscriber’s device. Make sure you assign the IP addresses properly.
• In general deployment, the computer must set the CPE device’s LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.
Use the following command sequence to configure the IES-1248-51V for this
example set up.
Figure 232 2684 Routed Mode Commands Example
ras> adsl rpvc gateway set 192.168.10.102 1
ras> adsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102
ras> adsl rpvc route set 1 8 35 10.10.10.1/24
Kommentare zu diesen Handbüchern