
Chapter 30 2684 Routed Mode
IES-1248-51V User’s Guide
233
To open this screen, click Advanced Application > 2684 Routed Mode >
Routed Domain.
Figure 108 2684 Routed Domain
The following table describes the labels in this screen.
Table 66 2684 Routed Domain
LABEL DESCRIPTION
Port Use this drop-down list box to select a port for which you wish to
configure settings.
VPI Type the Virtual Path Identifier for this routed PVC.
VCI Type the Virtual Circuit Identifier for this routed PVC.
IP Enter the subscriber’s CPE LAN IP address in dotted decimal notation.
NetMask The bit number of the subnet mask of the subscriber’s IP address. To
find the bit number, convert the subnet mask to binary and add all of
the 1’s together. Take “255.255.255.0” for example. 255 converts to
eight 1’s in binary. There are three 255’s, so add three eights together
and you get the bit number (24).
Add Click Add to save your changes to the IES-1248-51V’s volatile
memory.
The IES-1248-51V loses these changes if it is turned off or loses
power, so use the Config Save link on the navigation panel to save
your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to start configuring the screen again.
Index This field displays the number of the routed PVC.
Port This field displays the number of the ADSL port on which the routed
PVC is configured.
VPI This field displays the Virtual Path Identifier (VPI) The VPI and VCI
identify a channel on this port.
VCI This field displays the Virtual Circuit Identifier (VCI). The VPI and VCI
identify a channel on this port.
Kommentare zu diesen Handbüchern